Graco ProMix PD2K Operation page 109

Miscellaneous Miscellaneous Errors Miscellaneous Errors Errors
NOTE: NOTE: NOTE: In some error codes listed below, a # symbol is shown as the last digit. This symbol represents the applicable
component number, which can vary. The unit's display will show the applicable number as the last digit in the
code. For example, the B9D# code listed in this table will be displayed as B9D1 if the affected component is pump
1, B9D2 for pump 2, and so on.
Code Type
Code Code Type Type
B9A# Advisory
B9AX Advisory
B9B# Advisory
B9BX Advisory
B9D# Advisory
B9S1 Advisory
B9S2
B9S3 Advisory
B9S4
WX00 Alarm
Calibration Errors Errors
Calibration Calibration Errors
NOTE: NOTE: In some error codes listed below, a # symbol is shown as the last digit. This symbol represents the applicable NOTE:
component number, which can vary. The unit's display will show the applicable number as the last digit in the
code. For example, the ENT# code listed in this table will be displayed as ENT1 if the affected component is pump
1, ENT2 for pump 2, and so on.
Type
Code Code Code Type Type
END# Record
ENS# Record
Record
ENT#
3A4486D
Description Problem
Description Description Problem Problem
Volume Batch counter for
Rollover A material A rolled over
Current Mix for Mix Unit #.
Unit #
Volume Grand total counter for
Rollover A material A rolled over.
Lifetime
Volume Batch counter for
Rollover B material B rolled over
Current Mix for Mix Unit #.
Unit #
Volume Grand total counter for
Rollover B material B rolled over.
Lifetime
Volume Grand total counter for
Rollover Pump pump # rolled over.
#
Volume Batch counter for
Rollover solvent rolled over for
Solvent Mix Unit 1 (1) or Mix
Current Mix Unit 2 (2).
Unit #
Volume Grand total counter for
Rollover solvent rolled over for
Solvent Mix Unit 1 (3) or Mix
Lifetime Unit 2 (4).
Software An unexpected
Errors software error has
occurred.
Name
Name Name
Calibration Pump #
Calibration Solvent Meter #
Calibration Stall Test Pump # A stall test was completed successfully on
Cause
Cause Cause
The totalizer has
reached maximum
capable value and
started over at zero.
The totalizer has
reached maximum
capable value and
started over at zero.
The totalizer has
reached maximum
capable value and
started over at zero.
The totalizer has
reached maximum
capable value and
started over at zero.
The totalizer has
reached maximum
capable value and
started over at zero.
The totalizer has
reached maximum
capable value and
started over at zero.
The totalizer has
reached maximum
capable value and
started over at zero.
Description
Description Description
A calibration test was run on the pump.
A calibration test was run on the solvent
meter.
pump #.
System Errors
Solution
Solution Solution
n/a
n/a
n/a
n/a
n/a
n/a
n/a
Call Graco technical
support.
109