M.2 Ssd - Dell EMC PowerEdge XE7440 Installation And Service Manual

Figure 58. Installing the M.2 riser card
Next steps
1. Install the FE1 air duct.
2. Install the FE1 card.
3. Install the air shroud (FH
4. Install the sled.
5. Follow the procedure listed in

M.2 SSD

Removing the M.2 SSD
Prerequisites
1. Follow the safety guidelines listed in the
2. Follow the procedure listed in the
3. Remove the sled .
4. Remove the air shroud (FH sled)
5. Remove the FE1 card.
6. Remove the FE1 air duct.
7. Remove the M.2 riser
Steps
1. Open the M.2 clip hook that holds the M.2 SSD to M.2 riser board. Pull out the M.2 SSD.
NOTE: The numbers on the image do not depict the exact steps. The numbers are for representation of sequence.
92 Installing and removing system components
sled).
After working inside your
Safety
Before working inside your
.
card.
system.
instructions.
system.