Motherboard Bridge Board (2); Removing The Motherboard Bridge Board (2) - Dell EMC PowerEdge XE7440 Installation And Service Manual

Figure 50. Installing the Motherboard bridge board (1)
Next steps
1. Install the sled cables
2. Install the motherboard interposer
3. Install the motherboard bridge
4. Install the cooling fans.
5. Install the mini PERC card
6. Install the PCIe dummy
7. Install the air shroud.
8. Install the sled.
9. Follow the procedure listed in

Motherboard bridge board (2)

Removing the Motherboard bridge board (2)

Prerequisites
1. Follow the safety guidelines listed in the
2. Follow the procedure listed in the
3. Remove the sled.
4. Remove the the air shroud (FH sled
5. Remove the cooling fans.
Steps
1. Using the Phillips #2 screwdriver, remove the three screws that secure the motherboard bridge board (2) to the
motherboard bridge module bracket.
2. Disconnect the power cable from the motherboard bridge board (2) connector.
3. Lift the motherboard bridge board (2) out of the motherboard bridge module bracket.
84 Installing and removing system components
kit.
board.
module.
module.
bracket.
After working inside your
Safety
Before working inside your
).
system.
instructions.
system.