Table of Contents
Advertisement
you replace this system board, you must supply the recovery key when you restart your system or program
before you can access the encrypted data on your drives.
1. Follow the safety guidelines listed in the
2. Follow the procedure listed in the
3. Remove the following components:
a.
Sled
b.
Air shroud
c.
PCIe dummy bracket
d.
Mini PERC module
e.
OCP card
f.
Sled cable kit
g.
Motherboard bridge board module
h.
cable M2 riser card
i.
FH riser board
j.
System memory
k.
Processor and heat sink
Steps
1. Using a Phillips #2 screwdriver, remove the eight screws securing the system board to the chassis.
NOTE:
Do not lift the system board by holding a memory module slot, any other connector, or component.
2. Slightly lift the system board and slide it towards the front of the chassis.
3. Lift the system board out of the chassis.
Figure 85. Removing the system board
Next steps
Install the system
board.
Safety
instructions.
Before working inside your
system.
Installing and removing system components
117
Hide quick links:
Advertisement
Table of Contents
