Installing The Ocp Card - Dell EMC PowerEdge XE7440 Installation And Service Manual

Steps
1. Push the blue retention clips away on one side and release the OCP card.
2. Repeat the step 1 to release the card from the clips on the other side.
3. Slide the card toward the front of the sled to disengage the connectors from the sled and lift the card up.
Figure 37. Removing the OCP card
Next steps
Install the OCP card.

Installing the OCP card

Prerequisites
Follow the safety guidelines listed in the Safety instructions.
Steps
1. Insert the OCP card into the sled, aligning the connector on the card with the connector in the system board.
2. Align the holes on the card with the guide pins on the blue retention clips.
3. Push down to lock the OCP card in place.
72 Installing and removing system components