Table of Contents
Advertisement
Steps
1. Locate the MicroSD card slot on the IDSDM module. Orient the MicroSD card appropriately and insert the contact-pin end of
the card into the slot. To locate IDSDM, see the System board jumpers and connectors section.
NOTE:
The slot is keyed to ensure correct insertion of the card.
2. Press the card into the slot to lock it into place.
Figure 67. Installing the MicroSD card
Next steps
1.
Install the IDSDM
module.
2.
Install the air
shroud.
3. Follow the procedure listed in the
M.2 SSD module on BOSS-S1 adapter card
Removing the M.2 SSD module
Prerequisites
1. Follow the safety guidelines listed in the
2. Follow the procedure listed in the
3.
Remove the air
shroud.
4. Remove the BOSS card.
NOTE:
The procedure to remove the BOSS card is similar to removing an expansion card.
Steps
1. Using the Phillips #1 screwdriver, remove the screws securing the M.2 SSD module to the BOSS card.
2. Pull the M.2 SSD module to disconnect from the connector on the BOSS card.
NOTE:
The numbers on the image do not depict the exact steps. The numbers are for representation of sequence.
After working inside your
Safety
instructions.
Before working inside your
system.
system.
Installing and removing system components
73
Advertisement
Table of Contents
