Table of Contents
Advertisement
Installing the system board
Prerequisites
NOTE:
Before replacing the system board, replace the old iDRAC MAC address label in the Information tag with the iDRAC
MAC address label of the replacement system board.
1. Follow the safety guidelines listed in the
2. Follow the procedure listed in
3. If you are replacing the system board, remove all the components that are listed in the
Steps
1. Unpack the new system board assembly.
CAUTION:
Do not lift the system board by holding a memory module, processor, or other components.
CAUTION:
Take care not to damage the system identification button while placing the system board into the
chassis.
2. Holding the system board holder, lower and push the system board towards the back of the system until it is seated.
3. Using a Phillips #2 screwdriver, fasten the eight screws that secure the system board to the chassis.
Figure 86. Installing the system board
Next steps
1. Replace the following components:
a.
Trusted Platform Module (TPM)
NOTE:
The TPM Module must be replaced only while installing new system board.
b.
Processor and heat sink
c.
Sytem memory
118
Installing and removing system components
Safety
instructions.
Before working inside your
system.
removing the system board
section.
Hide quick links:
Advertisement
Table of Contents
