Dell EMC PowerEdge XE7440 Installation And Service Manual page 99

Steps
1. Using the Phillips #1 screwdriver, remove the three screws that secure the FH riser board to the sled.
2. Lift the FH riser module from the PCIe slot of system board.
Figure 66. Removing the FH riser module
3. Using the Phillips #2 screwdriver, remove the two screws that secure the FHFL interposer board to FH riser module.
4. Slide out and lift the FHFL interposer board from the FH riser board.
Figure 67. Removing the FHFL interposer board
Next steps
Install the FHFL interposer board.
Installing and removing system components 99