Motherboard Bridge Module; Removing The Motherboard Bridge Module - Dell EMC PowerEdge XE7440 Installation And Service Manual

Figure 38. Installing the OCP card
Next steps
1. Install the mini PERC
2. Install the PCIe dummy
3. Install the air shroud.
4. Install the sled.
5. Follow the procedure listed in

Motherboard bridge module

Removing the motherboard bridge module

Prerequisites
1. Follow the safety guidelines listed in the
2. Follow the procedure listed in the
3. Remove the sled.
4. Remove the air shroud.
5. Remove the PCIe dummy
6. Remove the mini PERC card
7. Remove the cable M.2 riser
8. Remove the cooling fans.
module.
bracket.
After working inside your
Safety
Before working inside your
bracket.
module.
board.
system.
instructions.
system.
Installing and removing system components 73