Sled; Removing The Sled; Installing The Sled - Dell EMC PowerEdge XE7440 Installation And Service Manual

Sled

Removing the sled

Prerequisites
1. Follow the safety guidelines listed in
2. Follow the procedure listed in the
Steps
1. Loosen the captive screw.
2. Pull the sled lever from under the sled.
3. Using sled handle, slide the sled out of the enclosure.
Figure 13. Removing the sled
Next steps
1. Install the sled.

Installing the sled

Prerequisites
Follow the safety guidelines listed in
Steps
1. Hold the sled on both sides and slide the sled into the enclosure until the sled is locked to the enclosure.
2. Push the sled lever under the sled and tighten the captive screws.
Safety instructions.
Before working inside your
Safety instructions.
system.
Installing and removing system components 47