Installing The Fe1 Card - Dell EMC PowerEdge XE7440 Installation And Service Manual

4. Press latch and slide out the card holder.
5. Slide out and lift the FE1 card module from the FHFL interposer board.
NOTE: The numbers on the image do not depict the exact steps. The numbers are for representation of sequence.
Figure 53. Removing the FE1 card
Next steps
Install the FE1 card.

Installing the FE1 card

Prerequisites
Follow the safety guidelines listed in the
Steps
1. Connect the power cable.
2. Align and slide in the FE1 card into the FHFL interposer board. Press until the FE1 card module clicks into place.
3. Ensure PCIe bracket assembly in place.
4. Slide in the card holder.
5. Rotate to close the holder bracket.
6. Using the Phillips #1 screwdriver, secure the holder bracket with a screw.
NOTE: The numbers on the image do not depict the exact steps. The numbers are for representation of sequence.
Safety instructions.
Installing and removing system components 87