Motherboard Bridge Board; Removing The Motherboard Bridge Board (1) - Dell EMC PowerEdge XE7440 Installation And Service Manual

Figure 48. Installing the sled cable kit (1)
Next steps
1. If required, Install the air shroud (FH
2. Connect the mini PERC cable to the mini PERC module.
3. Connect the cables to the cable M.2 riser board.
4. If required, install the motherboard bridge
5. Install the mini PERC
6. Install the PCIe dummy
7. Install the air shroud.
8. Install the sled.
9. Follow the procedure listed in

Motherboard bridge board

Removing the Motherboard bridge board (1)

Prerequisites
1. Follow the safety guidelines listed in the
2. Follow the procedure listed in the
3. Remove the sled.
4. Remove the air shroud.
82 Installing and removing system components
sled).
module.
module.
bracket.
After working inside your
Safety
Before working inside your
system.
instructions.
system.