Table of Contents
Advertisement
Air shroud
Removing the air shroud
Prerequisites
CAUTION:
Never operate your system with the air shroud removed. The system may get overheated quickly,
resulting in shutdown of the system and loss of data.
1. Follow the safety guidelines listed in the
2. Follow the procedure listed in the
3.
Remove the
sled.
Steps
1. Hold the air shroud touch points at both ends and lift the air shroud out of the system.
2. Push the retention clip down and lift the mini PERC card battery out of the air shroud.
NOTE:
Observe the cable routing of the mini PERC card battery, that is below the air duct and goes between heat sink
and memory sockets.
Figure 15. Removing the air shroud
Next steps
Install the air
shroud.
Safety
instructions.
Before working inside your
system.
Installing and removing system components
49
Hide quick links:
Advertisement
Table of Contents
