Sled Cables Kit; Removing The Sled Cables Kit - Dell EMC PowerEdge XE7440 Installation And Service Manual

Figure 44. Installing the motherboard interposer board
Next steps
1. Install the motherboard bridge
2. Install the cooling fans.
3. Install the cable M.2 riser
4. Install the mini PERC card
5. Install the PCIe dummy
6. Install the air shroud.
7. Install the sled.
8. Follow the procedure listed in

Sled cables kit

Removing the sled cables kit

Prerequisites
1. Follow the safety guidelines listed in the
2. Follow the procedure listed in the
3. Remove the sled.
4. Remove the air shroud.
5. Remove the PCIe dummy
78 Installing and removing system components
module.
board.
module.
bracket.
After working inside your
Safety instructions.
Before working inside your
bracket.
system.
system.