6.
Remove the mini PERC card
7. Disconnect the mini PERC cable from the mini PERC module.
8. Disconnect the cables from the cable M.2 riser board.
9. If required,
remove the motherboard bridge
10. If required,
remove the air shroud (FH
Steps
1. Using the Phillips #2 screwdriver, remove the four screws that secure the sled cable kit (2) to the sled.
2. Lift the sled cable kit (2) from the sled.
Figure 45. Removing the sled cables kit (2)
3. Using the Phillips #2 screwdriver, remove the four screws that secure the sled cable kit (1) to the motherboard bridge
module.
4. Lift the sled cable kit (1) from the motherboard bridge module.
module.
module.
sled).
Installing and removing system components
79