Steps
1. Using the Phillips #1 screwdriver, remove the two screws that secure the motherboard bridge module to the sled.
2. Disconnect the cable from the system board connector.
NOTE:
Observe the routing of the cable as you remove the motherboard bridge module from the sled.
3. Slide out the motherboard bridge module from the sled.
Figure 39. Removing the motherboard bridge module
Next steps
Install the motherboard bridge
Installing the motherboard bridge module
Prerequisites
Follow the safety guidelines listed in the
Steps
1. Align and insert the motherboard bridge module into the sled.
2. Connect the cable to the system board connector.
NOTE:
Route the cable properly to prevent the cable from being pinched or crimped.
3. Using the Phillips #1 screwdriver, secure the motherboard bridge module to the sled with two screws.
74
Installing and removing system components
module.
Safety
instructions.