Fe1 Card; Removing The Fe1 Card - Dell EMC PowerEdge XE7440 Installation And Service Manual

Figure 52. Installing the Motherboard bridge board (2)
Next steps
1. Install the cooling fans.
2. Install the air shroud (FH
3. Install the sled.
4. Follow the procedure listed in

FE1 card

Removing the FE1 card

Prerequisites
1. Follow the safety guidelines listed in the
2. Follow the procedure listed in the
3. Remove the sled.
4. Remove the air shroud (FH
Steps
1. Disconnect the power cable.
2. Using the Phillips #1 screwdriver, remove the screw that secures the FE1 card holder bracket.
3. Rotate to open the holder bracket.
86 Installing and removing system components
sled).
After working inside your
Safety instructions.
Before working inside your
sled).
system.
system.