Dell EMC PowerEdge XE7440 Installation And Service Manual page 34

Network Settings screen details
The Network Settings screen details are explained as follows:
About this task
Option Description
UEFI PXE
Options
Settings
PXE Device n (n
= 1 to 4)
PXE Device n Enables you to control the configuration of the PXE device.
Settings(n = 1 to
4)
UEFI HTTP
Options
Settings
HTTP Device (n =
1 to 4)
HTTP Device n Enables you to control the configuration of the HTTP device.
Settings (n = 1 to
4)
TLS View and/or modify this device's boot TLS authentication mode. None means the HTTP server and the
Authentication client will not authenticate each other for this boot. One way means the HTTP server will be
Configuration authenticated by the client, while the client will not be authenticated by the server. This option is set to
None by default.
Integrated Devices
You can use the Integrated Devices screen to view and configure the settings of all integrated devices including the video
controller, integrated RAID controller, and the USB ports.
Viewing Integrated Devices
To view the Integrated Devices screen, perform the following steps:
Steps
1. Power on, or restart your system.
2. Press F2 immediately after you see the following message:
F2 = System Setup
NOTE: If your operating system begins to load before you press F2, wait for the system to finish booting, and then
restart your system and try again.
3. On the System Setup Main Menu screen, click System BIOS.
4. On the System BIOS screen, click Integrated Devices.
Integrated Devices details
About this task
The Integrated Devices screen details are explained as follows:
34 Pre-operating system management applications
Description
Enables or disables the device. When enabled, a UEFI PXE boot option is created
for the device.
Description
Enables or disables the device. When enabled, a UEFI HTTP boot option is created
for the device.