Table of Contents
Advertisement
b.
All expansion cards and risers
c.
Integrated storage controller card
d.
Internal USB key (if applicable)
e.
USB 3.0 module (if
f.
Processors and heat sink modules
g. Processors blanks (if installed)
CAUTION:
To prevent damage to the processor socket when replacing a faulty system board, ensure that
you cover the processor socket with the processor dust cover.
h.
Memory modules
and memory module blanks
i.
Network daughter card
Steps
1. Disconnect all cables from the system board.
CAUTION:
Take care not to damage the system identification button while removing the system board from
the chassis.
2. Holding the post, lift the blue release pin, and slide the system board toward the front of the system to disengage the
connectors from the slots on the chassis.
3. Incline the system board at an angle, and lift the system board out of the chassis.
Figure 116. Removing the system board
Next steps
Install the system
board.
Installing the system board
Prerequisites
Follow the safety guidelines listed in
Steps
1. Unpack the new system board assembly.
126
Installing and removing system components
applicable))
Safety instructions
on page 34.
Advertisement
Table of Contents
