Table of Contents
Advertisement
4. Incline the system board at an angle, and lift the system board out of the chassis.
Figure 77. Removing the system board
Next steps
Install the system
board.
Installing the system board
Prerequisites
1. Follow the safety guidelines listed in
2. Follow the procedure listed in
3. Remove the following:
a.
System
cover.
b.
Air
shroud.
c.
Memory
modules.
d. Processor.
e. Heatsink.
f.
Expansion card
riser(if installed).
g.
Internal PERC card
Steps
1. Unpack the new system board.
CAUTION:
Do not lift the system board by holding a memory module, processor, or other components.
2. Holding the system board holder lower the system board in to the chassis.
3. Incline the system board at an angle, align the connectors with the slots on the rear of the system and push the system
board till firmly seated.
4. Install and tighten the eight screws to secure the system board in place,
104
Installing and removing system components
Safety
instructions.
Before working on your system
or
Front PERC riser
(if installed).
Advertisement
Table of Contents
