Installing The System Board - Dell 34PR7 Installation And Service Manual

Steps
1. Using the system board holder, slide the system board toward the front of the chassis.
2. Incline the system board at an angle and lift the system board out of the chassis.
Figure 77. Removing the system board
Next steps
Install the system board.

Installing the system board

Prerequisites
NOTE: Before replacing the system board, replace the old iDRAC MAC address label on the Information tag with the iDRAC
MAC address label of the replacement system board.
1. Follow the safety guidelines listed in the
2. Follow the procedure listed in
3. If you are replacing the system board, remove all the components that are listed in the
Steps
1. Unpack the new system board assembly.
CAUTION: Do not lift the system board by holding a memory module, processor, or other components.
CAUTION: Take care not to damage the system identification button while placing the system board into the
chassis.
2. Using the system board holder, lower the system board into the system.
3. Incline the system board at an angle and align the connectors on the system board with the slots on the rear of the chassis
until the connectors are firmly seated in the slots.
82 Installing and removing system components
Safety instructions.
Before working inside your system.
Removing the system board section.