4. Rewind the wire on which the D terminal
is attached on the paper feed side pulley
from the bottom to the top, and fit in the
wire holder jig (Small). Next, rewind on
pulley 1 on carriage 2 from the top to the
bottom and hang the D terminal on the
hook.
5. Lead in the wire on which the tension
spring is attached as shown in the figure
on the right, and hang the tension spring
on the hook.
7.7.24
Slit glass, mirror 6 cover
(1)
Remove the process unit.
Nov. 1997 © TOSHIBA
Paper feed side pulley
D terminal
Carriage drive wire
Tension spring
[Rear side]
7 - 35
Carriage drive wire
Pulley 1
Hook
Carriage 2
Hook
[Front side]
Mirror 6 cover hook
4560/4570 OPTICAL