Toshiba 4560 Service Manual page 131

(3) Remove the connectors for the transfer/sepa-
ration charger (front side) and the main charger
(rear side).
(4) Remove the 2 connectors and 3 screws and
take out the high-voltage transformer.
9.4.9 Lower damp heater, fuse PC board, and
thermostat
(1) Remove the transfer/separation charger, trans-
port-belt unit and toner suction duct unit.
(2) Remove the screw, pull out the connector, and
take out the entire bracket.
(3) Pull out the connector on the fuse PC board
and the 2 Faston terminals for the thermostat.
Remove the screw and the washer. Take out
the lower damp heater.
(4) Remove the connector and take off the fuse
PC board from the lock support.
(5) Pull out the 2 Faston terminals, remove the
screw and take off the thermostat.
Nov. 1997 © TOSHIBA
Hooks
High-voltage
transformer
Faston terminals
Lower damp heater
9 - 17
Main charger connector
[Rear side]
Connectors
Transfer/separation
charger connector
Hooks
[Front side]
Thermostat
fixing screw
Thermostat
Fuse PC board
Connector
4560/4570 DRUM