18.13.10 Separation plate
(1) Remove the feed unit.
(2) Open the jam access cover.
(3) Remove two screws.
18.13.11 Aligning roller (L)
(1) Remove the feed unit.
(2) Remove the jam access cover.
(3) Remove an E-ring, bushing and coil spring from
the front and rear sides.
(4) Slide the aligning roller (L) to pull it out.
18.13.12 Aligning sensor and size sensors 1
and 2
(1) Remove the feed unit.
(2) Remove four screws
4560/4570 RADF
18 - 70
Adjusting screw
Separation plate
Aligning roller(L)
Entrance guide
Nov. 1997 © TOSHIBA