Notes: 1. When fitting the transfer/separation
charger, insert it in the placement groove
on the rear frame. Also check that it can
be pushed up by the spring and moves
up and down.
2. Do not forget to insert the connector.
[A] Replacing the charger wire:
Total length: 353 mm
Gold-plated tungsten wire: ø0.06 mm
(1) Remove the terminal cover on the front
and rear. In the case of the separation
charger, remove the supporter.
4560/4570 DRUM
Spring
Transfer/
V-groove
separation
charger
Terminal
Charge wire terminal
Charge wire terminal
Charge wire
V-groove
9 - 12
[Rear side]
Supporter
Charge wire
[Front side]
Spring
[Rear side]
Nov. 1997 © TOSHIBA