Toshiba 4560 Service Manual page 129

[A] To place the belt:
(1) Remove the idle roller on the drum side.
(2) Remove the stop-ring and the shaft.
(3) Remove the belt case (4 screws).
(4) Remove the belt.
Note: The belt position for installation is shown in
the figure below.
Transport belt
Notes: 1. To reinstall the transport-belt unit in the
copier, fit its rear guide projection (2) in
the hole in the rear copier frame and the
front guide projection in the cut-out por-
tion of the front copier frame.
2. Check that the gears on the front and rear
are properly engaged.
9.4.7 Toner suction duct unit
(1) Remove the transfer/separation charger and
transport belt unit.
(2) Remove the screw and take out the toner suc-
tion duct.
Nov. 1997 © TOSHIBA
Idle roller on drum side
5 ± 1 mm
Front side
Rear side guide
projection
Gear
Toner suction duct
9 - 15
Drum side
idle roller
Belt case
Shaft
Belt Stop-ring
4560/4570 DRUM