Toshiba 4560 Service Manual page 112

[B] Paper dust cleaning brush
(1) Remove the brush (1 screw).
(When the unit is installed in the machine, the
brush can be removed/installed if the transfer/
separation charger has been taken out).
8.4.4 Cassette feed section
(1) Remove the right feed cover.
(2) Open the jam release cover.
(3) Remove the stop ring from the bottom of the
hinge.
(4) Remove the harness cover.
(5) Remove the jam release cover.
(6) Disconnect the connector from the feed unit.
(7) Pull out the cassette.
(8) Disconnect the paper size detection switch
harness from the switch.
(9) Remove the two paper feed unit fixing screws,
and pull out the unit toward the front side.
Nov. 1997 © TOSHIBA
Aligning roller (U)
Connector
Stop ring
Paper feed unit
8 - 13
Aligning roller (L)
Paper dust brush
Jam release cover
Harness cover
Harness
4560/4570 FEEDER