Toshiba 4560 Service Manual page 95

(5) Remove the stopper ring and bearing in front
and rear side.
(6) Remove the whole wire drive shaft.
(7) Remove the carriage drive wire from the wire
drive pulley.
Note: How to wind the carriage drive wires
1. Fit the end "D" of the carriage drive wire
in the groove of the wire drive pulley and
wind the carriage drive wire in the direc-
tion and the number of turns shown in the
figure on the right. (Do not allow the wire
to twist while winding it.)
2. Install the wire holder jig (Large) from the
side indicated with an arrow.
Nov. 1997 © TOSHIBA
Bearing
Color: Black
Wire holder jig
(Large)
7 - 33
Bearing
Stop-ring
[Rear side]
Stop ring
[Front side]
[Front side]
End "D"
1
5 turns 1 turns
2
4560/4570 OPTICAL