12.5.6
Heat roller separation claw
(1) Remove the separation claw unit (2 screws,
golden color).
(2) Draw out the shaft (1 screw).
(3) There are 6 separation claws in all. Remove
them all from their each spring.
Note: Check that the edges (tips) of the claws are
not chipped.
12.5.7
Thermistor and thermostat
(1) Remove the bracket on which the thermistor
and thermostat are attached (2 screws).
(2) Remove the 2 thermistors (1 screw each).
• Be careful not to deform the root of the ther-
mistor harness.
(3) Unscrew 2 screws and take off the thermostat
from the holder.
Note: When installing, make sure the thermistor
and thermostat both contact the heat roller
surface evenly.
4560/4570 FUSER
Separation claw
Spring
Thermostat
Thermistor
12 - 12
Shaft
Nov. 1997 © TOSHIBA