Toshiba 4560 Service Manual page 183

(6) Remove the bushing from the rear end of the
pick-up roller shaft and the stop-ring at the rear
of the pick-up roller. Then, take the pick-up roller
(2 pieces) out toward the rear.
[D] ADU stack/feed rollers (Main and sub)
(1) Take out the upper paper guide by removing two
screws.
Take out the open guide stopper from the open
guide (lower) after removing one stop-ring.
(2) Remove the open guide units (upper and lower)
by removing two stop-rings and one snap-ring.
(3) Remove the stop-ring on each end of the ADU
stack/feed roller shaft, and push the bushing
toward the inside.
(4) Remove the four pick-up roller guides from the
pick-up roller shaft by pushing them downward.
Then, lift the rear end of the shaft.
4560/4570 ADU
Pick-up roller
ADU stack/feed
roller (sub)
Stop ring
ADU stack/feed roller (main)
Bush
Stop-ring
13 - 16
Pick-up roller guide
ADU stack/feed
roller (sub)
Stop ring
ADU stack/feed roller
Nov. 1997 © TOSHIBA