(4) Take off the entrance paper guide by unscrew-
ing the two screws.
(5) Lift up the pressure roller holding both ends,
and take the pressure roller out with its bear-
ings.
Note: When installing the pressure roller, make
sure the bearing grooves on both the front
and rear are set in the pressure levers.
Bearing
Pressure lever
12.5.5
Cleaning felt roller, cleaning roller
(1) Remove the pressure bracket (2 screws).
(2) Remove the roller by lifting it.
Nov. 1997 © TOSHIBA
Pressure roller
12 - 11
Entrance paper guide
Pressure roller
Bearing
Cleaning roller
Cleaning felt roller
4560/4570 FUSER