Component Testing - Toro Greensmaster 1018 Service Manual

Component Testing

Electrical System: Component Testing
For accurate resistance and/or continuity checks, electrically disconnect the
component being tested from the circuit (e.g. unplug the ON/OFF switch
connector before doing a continuity check). Individual components should be
electronically isolated (e.g. disconnect all leads or remove the circuit) from the
circuit when tested.
Note: See the Honda Service Manual for the engine components testing
information.
When testing the electrical components for the continuity with a
multimeter (ohm setting), ensure that the power to the circuit has
been disconnected.
The ignition system produces a dangerously high voltage. Do not
touch the spark plug lead ignition coil, igniter, or spark plug lead
while the engine is running; you can receive a severe electrical
shock.
CAUTION
WARNING
Page 6–4 Greensmaster ® 1018/1021/1026
18238SL Rev B