Toro Greensmaster 1018 Service Manual page 155

Inspecting the Reel Assembly (continued)
Installing the Reel Assembly
Greensmaster ® 1018/1021/1026
18238SL Rev B
Note: The reel nut on the left end of the cutting reel has a black finish and
has left-hand threads. The left end of the cutting reel shaft is identified with a
groove cut just inside of the left-most reel spider. Tighten the reel nuts to the
specified torque once the cutting reel is installed in the cutting unit.
6. Install the reel nuts finger tight.
1. Position the cutting unit on a flat work area.
Contact with the reel, bedknife or other cutting unit parts can result
in personal injury. Use heavy gloves when installing the cutting reel.
2. Apply a thin coat of grease to the outside of the cutting reel bearings and
carefully slide the cutting reel assembly into the right side plate. Make sure
that the reel bearing is fully seated in the RH side plate, and that the reel nut
on the left (exposed) end of the cutting reel has a black finish.
3. Place the grass shield assembly (18), frame support rods (9 and 14) onto
the RH side plate (10).
4. Place the flat wire spring into bearing bore of LH side plate and carefully
slide the left side plate onto the cutting reel assembly as far as possible.
5. Install the 4 socket head screws (3 and 17) that secure the RH and LH side
plates (4 and 10) to the frame support rods (9 and 14). Tighten the socket
head screws from 24 to 27 N∙m (18 to 20 ft-lb).
6. Secure the grass shield assembly (18) to the RH and LH side plates (4 and
10) with the 2 washers (15) and 2 bolts (16).
7. If the reel nuts were loosened during cutting reel service, put a block of wood
between the cutting reel blades to prevent the reel from rotating and tighten
the reel nuts from 123 to 149 N∙m (90 to 110 ft-lb).
8. Install the reel drive assembly; refer to
(page 5–10). Grease the splines with high temp Mobil XHP−222 grease
or equivalent.
9. Install the bedbar assembly; refer to
10. Install the front roller; refer to
11. Install the cutting unit assembly to the frame assembly; refer to
Cutting Unit Assembly (page
12. If the cutting unit is equipped with an optional groomer, install the components
for those options. Refer to
universal groomer, and
information.
CAUTION
Installing the Reel Drive Assembly
Installing the Bedbar (page
Installing the Front Roller (page
8–17).
Installing the Gear Box Assembly (page 9–8)
Installation Instructions (page 9–2)
Page 8–21
8–8).
8–26).
Installing the
for additional
DPA Cutting Units: Service and Repairs
for