The Idler Assembly - Toro Greensmaster 1018 Service Manual

The Idler Assembly

Removing the Idler Assembly
Greensmaster ® 1018/1021/1026
18238SL Rev B
g282209
1. Cotter pin
2. Flange nut
3. Flocked seal (2 each)
4. Bushing
5. Stub shaft
The groomer idler assembly is located on the opposite side of the groomer gear
box.
Note: Refer to Figure 88
1. Remove the reel drive from the cutting unit; refer to
Assembly (page 8–18).
2. Remove the groomer reel assembly; refer to
(page 9–11).
3. Remove the cotter pin and clevis pin from the height adjustment rod at the
front of the idler arm. Discard the cotter pin.
4. Remove the flange nut that secures the idler arm to the stub shaft. Remove
the idler assembly.
5. Inspect the shields, bearing, and bushing in the idler assembly. Replace any
components that are worn or damaged.
Figure 88
6. Shield
7. Retaining ring
8. Bearing
9. Idler arm
10. Clevis pin
during this procedure.
Page 9–9 Universal Groomer (Optional): Service and Repairs
Removing the Reel
Removing the Groomer Reel