Cutting Unit Assembly - Toro Greensmaster 1018 Service Manual

Cutting Unit Assembly

g261511
1. Cutting unit assembly
2. Reel drive assembly
3. Socket head screw (4 each)
Removing the Cutting Unit Assembly
DPA Cutting Units: Service and Repairs
Note: Refer to Figure 77
1. Park the machine on a level surface on the traction drum. Ensure that the
engine is OFF and the traction control is in NEUTRAL.
2. Remove the spark plug wire from the engine spark plug.
3. Slide the telescopic coupler on the reel drive assembly (2) from the
transmission drive shaft.
Note: If necessary, remove the reel drive assembly (2) from the cutting unit
assembly (1); refer to
4. Remove the 4 socket head screws (3) that secures the cutting unit assembly
(1) to the frame assembly (5).
Note: Support the traction unit and lock the kick stand.
5. Slide and remove the cutting unit assembly (1) from the frame assembly (5).
6. If necessary, remove the dowel pins (4) from the frame assembly (5).
Figure 77
4. Dowel pin (4 each)
5. Frame assembly
during this procedure.
Removing the Reel Drive Assembly (page
Page 8–16
5–7).
Greensmaster ® 1018/1021/1026
18238SL Rev B