Toro Greensmaster 1018 Service Manual page 62

Disassembly of Reel Drive Assembly
g258688
1. Reel shaft-driven
2. O-ring
3. Pivot sleeve
4. Reel drive gasket
5. Ball bearing (2 each)
6. Internal snap ring
7. Reel pulley spacer (2 each)
8. Reel pulley - 24 tooth
9. Lock nut (2 each)
10. Idler bushing
Traction and Reel Drive Systems: Service and Repairs
11. Socket head screw
12. Socket head screw (3 each)
13. Expansion plug
14. Reel drive cover
15. Reel pulley - 22 tooth
16. Reel belt
17. Retaining ring
18. Ball bearing (4 each)
19. Flocked bearing shield
20. Hipro key
Note: Refer to Figure 23
1. Remove the reel drive belt (item 16 in
Reel Drive Belt (page
2. Remove and discard the reel drive gasket (4) from the reel drive housing (22).
3. If necessary, remove the expansion plug (13) from the reel drive cover (14).
4. Remove the hex bolt (28) and plain washer (27) from the idler arm (26) and
the nut (25) from the reel drive housing (22).
5. Loosen and remove the socket head screw (11) that secures the idler arm
(26) to the reel drive housing (22). Remove the idler arm and nut (25) from
the reel driving housing.
6. If necessary, remove the idler bushing (10) from the idler arm (26).
7. Remove the retaining ring (29) and use a press to remove 2 ball bearings
(18) from the idler arm (26). Discard the ball bearings after removal.
8. Remove the lock nut (9), reel pulley (8), hipro key (20) and spacer (7) from
the reel shaft-driven (1).
Figure 23
21.
22.
23.
24.
25.
26.
27.
28.
29.
during this procedure.
Figure
5–5).
Page 5–8
Reel shaft-driver
Reel drive housing
O-ring
Bolt
Lock nut (2 each)
Idler arm
Plain washer
Hex bolt
Retaining ring
23); refer to Removing the
Greensmaster ® 1018/1021/1026
18238SL Rev B