Toro Greensmaster 1018 Service Manual page 48

Removing the Engine (continued)
Gasoline Engine: Service and Repairs
g262386
1. Armature wire
4. Disconnect the electrical connections from the engine:
A. Unplug the wire harness connector from the engine armature wire (1).
B. Disconnect the wire harness ground wire (3) from engine by removing
LH rear cap screw, flat washer and a flange nut.
C. If the machine is equipped with optional lighting kit, disconnect the wire
harness connectors from the engine alternator wires (2).
5. Remove the 2 bolts (13) that secures the clutch cover (12) to the bell housing.
Remove the clutch cover from the bell housing.
6. Remove the 2 bolts (15) and 2 nuts (11) that secures the clutch hub clamp
(10) to the external clutch hub. Remove the clutch hub clamp from the
external clutch hub.
7. Remove the 4 bolts (8) and 4 washers (9) that secures the engine (14) to
the bell housing.
8. Remove the 4 nuts (3), 4 washers (4) and 4 carriage bolts (6) that secures the
engine (14) to the engine base (5). Remove the engine from the engine base.
9. If necessary, remove the muffler (2) from the engine (14) by removing the 2
bolts (1).
Figure 15
2. Alternator wire
Page 4–10
3. Harness ground wire
Greensmaster ® 1018/1021/1026
18238SL Rev B