Toro Greensmaster 1018 Service Manual page 88

Assembling the Transmission Gear Box Assembly (continued)
Traction and Reel Drive Systems: Service and Repairs
25. Slide and install the brake lever assembly (item 19 in
transmission housing assembly (23).
26. If removed, insert the brake mount pin through brake band into the
transmission housing assembly (item 23 in
spring (22) onto the transmission housing assembly.
27. Place the retainer plate (item 16 in
assembly (23) and secure it with the 4 bolts (8).
28. Slide and install the external retaining ring (item 1 in
lever (24) onto the brake lever (19) and secure it with the bolt (25).
29. If disassembled, assemble the differential assembly (item 14 in
refer to Assembly of Differential Assembly (page
30. Pack the differential assembly (item 14 in
a press to install the 2 ball bearing (13) and 2 flange bearings (12) into the
differential assembly.
31. Slide the V-ring seal (item 15 in
32. Apply a coat of grease to the 2 O-rings (item 10 in
O-rings to the differential shafts (9). Install the retaining rings (11) onto the
differential shaft (9).
33. Insert the 2 differential shafts (item 9 in
(14).
34. Insert the differential housing assembly (item 14 in
transmission housing assembly (23).
35. Insert the square keys (item 7 in
Apply a coat of grease to outer surface of the square keys (7).
36. Insert the neutral slider shaft (item 6 in
(5).
37. Use a press and insert the bearings (item 4 in
slider shaft (6).
38. Insert the wave washer (item 3 in
(5) into the transmission housing assembly (23). Make sure that the traction
selector shaft (item 19 in
gear (item 5 in Figure
39. Apply a coat of grease to ORB plug (item 8 in
detent ball (10), detent spring (9) and ORB plug (8) into the transmission
housing (26).
40. Torque tighten the ORB plug (8) from 3.6 to 4.7 N·m (32 to 42 in-lb).
41. Use a press and insert the ball bearing (item 25 in
transmission cover (23). Install the retaining ring (5) and oil seal (6) into
the transmission cover (23).
42. Ensure that the oil seal lip is orientated toward the center of the transmission
housing. Press the seal into the transmission housing bore so that the seal
is flush to the edge of the transmission housing.
43. Install the oil seal (item 14 in
44. Ensure that the oil seal lip is orientated toward the center of the transmission
housing. Press the seal into the transmission housing bore so that the seal
is flush to the edge of the transmission housing.
45. If removed, insert the 2 dowel pins (item 17 in
housing assembly (26).
Figure 34) onto the transmission housing
Figure
Figure 34) onto the differential assembly (14).
Figure
Figure 34) into the neutral slider shaft (6).
Figure
Figure 34) and neutral spur gear assembly
Figure 33) is engaged in shift selection neutral spur
34).
Figure 33) into the transmission cover (23).
Page 5–34
Figure 34) into the
Figure 34) and place the flat wire
Figure 34), cable brake
Figure
5–38).
34) with grease and use
Figure 34) and slide the
34) into the differential housing
Figure 34) into the
34) into the neutral spur gear
Figure 34) onto the neutral
Figure 33) and install the
Figure 33) into the
Figure 33) into the transmission
Greensmaster ® 1018/1021/1026
18238SL Rev B
34);