Toro Greensmaster 1018 Service Manual page 72

Disassembly of Drum Drive Assembly
g258879
1. Traction drum (2 each)
2. Bolt (8 each)
3. Lock washer (8 each)
4. Drum hub plate (2 each)
Traction and Reel Drive Systems: Service and Repairs
5. Drum spindle
6. Seal (2 each)
7. Ball bearing (2 each)
8. Spacer
Note: Refer to Figure 29
1. Remove the 4 bolts (item 2 in
the drum hub plate (4) to the drum spindle (5).
2. Remove the 4 bolts (2) and lock washers (3) that secures the drum hub
plate (4) to the drum hub (10).
3. Remove the shoulder bolts (11) that secures the drum hub plate (4) to the
traction drum (1).
4. Remove the lock nut (12) that secures the drum spindle (5) and drum hub
(10) together. Carefully slide and remove the drum spindle (5) out of the
drum hub (10).
5. Remove the 2 seals (6) from the drum hub (10). Use a press to remove the 2
ball bearings (7) and a bearing spacer (8) from the drum hub (10). Discard
the ball bearings.
Figure 29
10.
11.
12.
during this procedure.
Figure 29) and lock washers (3) that secures
Page 5–18
9. Spacer
Drum hub
Shoulder bolt (6 each)
Lock nut
Greensmaster ® 1018/1021/1026
18238SL Rev B