Toro Greensmaster 1018 Service Manual page 81

Disassembling the Transmission Gear Box Assembly (continued)
g259590
1. External retaining ring
2. Fitting plug
3. Wave washer
4. Ball bearing (2 each)
5. Neutral spur gear
6. Neutral slider shaft
7. Square key (2 each)
8. Bolt (4 each)
9. Differential shaft (2 each)
Greensmaster ® 1018/1021/1026
18238SL Rev B
3. Remove the oil seal (6), retaining ring (5) from the transmission cover (23).
Use a press to remove the ball bearing (25) from the transmission cover (23).
Discard the oil seals and ball bearing.
10. O-ring (2 each)
11. Retaining ring (2 each)
12. Flange bearing (2 each)
13. Ball bearing (2 each)
14. Differential assembly
15. V-ring seal
16. Retainer plate
17. Retaining ring
18. Brake band
4. Remove the neutral spur gear assembly (item 5 in
washer (3) from the transmission housing assembly (23).
5. Use a press to remove the ball bearings (4) from the neutral slider shaft
(6). Remove the square keys (7) from the neutral slider shaft (6). Discard
the ball bearings.
6. Remove the differential assembly (14) from the transmission housing
assembly (23).
7. Remove the 2 differential shafts (9) from the differential housing (14).
Remove the retaining rings (11) and O-rings (10) from the differential shafts
(9). Discard the O-rings.
Figure 34
19.
20.
21.
22.
23.
24.
25.
26.
Page 5–27 Traction and Reel Drive Systems: Service and Repairs
Brake lever
O-ring
Brake clevis pin
Flat wire spring
Transmission housing assembly
Cable brake lever
Bolt
Brake gasket plate
Figure 34) and wave