Toro Greensmaster 1018 Service Manual page 125

Disassembling the Handle Assembly (continued)
Assembling the Handle Assembly
Greensmaster ® 1018/1021/1026
18238SL Rev B
29. Remove the flange nut (item 8 in
clutch bail link (5) to the handle mount (7). Remove the 2 flange bushings
(3) and spacer tube (17) from the handle mount.
30. Remove the flange nut (8) and bolt (2) that secure the clutch bail assembly
(4) to the handle mount (7). Remove the clutch bail assembly from the
handle mount. Remove the compression spring (6), 2 flange bushings (3)
and spacer tube (17) from the handle mount.
31. Remove the 2 nuts (14) and 2 bolts (16) that secures the handle mount (7)
to the upper receiver weldment (15). Remove the handle mount from the
upper receiver weldment.
g313848
1. Lower handle assembly
2. Bolt
3. Washer (2 each)
32. If necessary, remove the nut (item 4 in
that secures the lower handle assembly (1) to the frame assembly (5).
1. If removed, install the lower handle assembly (item 1 in
frame assembly (5) and secure with the bolt (2), washers (3) and nut (4).
2. Lift the lower handle assembly to maximum top position and torque tighten
the bolt (2) to 5.6 to 6.2 N·m (50 to 55 ft-lb).
3. Install the handle mount (7) to the upper receiver weldment (15) and secure
with 2 bolts (16) and 2 nuts (14).
Figure 59), and bolt (2) that secure the
Figure 60
4. Nut
5. Frame assembly
Figure
Page 7–21 Controls, Wheels and Accessories : Service and Repairs
60), washers (3) and bolt (2)
Figure 60) onto the