Toro Greensmaster 1018 Service Manual page 64

Assembly of Reel Drive Assembly (continued)
g258764
1. Press flush
Installing the Reel Drive Assembly
Traction and Reel Drive Systems: Service and Repairs
19. Install the bolt (28), washer (27) and nut (25) to the idler arm (26) and reel
drive housing (22). Do not tighten the bolt (28).
20. If removed, install the expansion plug (13) to the reel drive cover (14) and
press flush to outer surface (refer to
21. Install the reel drive belt; refer to
22. Adjust the reel drive belt tension; refer to
5–3).
Note: Refer to Figure 22
1. Place the V-ring seal (5) into the reel drive assembly (6).
2. Install the compression spring (7) and telescopic coupler (8) to the reel
drive shaft.
3. Install the reel drive assembly (6), washers (3), spring washer (4) and spacers
(2 and 11) to the RH side plate (9) and secure the reel drive assembly (6)
with 2 screws (1) and nut (12).
4. Slide the compression spring (7) and telescopic coupler (8) to the
transmission gear shaft (10).
5. Attach the spark plug wire to the spark plug.
Figure 24
Figure
Installing the Reel Drive Belt (page
Adjusting the Reel Drive Belt (page
during this procedure.
Page 5–10
24) of the reel drive cover.
Greensmaster ® 1018/1021/1026
18238SL Rev B
5–6).