Toro Greensmaster 1018 Service Manual page 54

Installing the Engine Base (continued)
Gasoline Engine: Service and Repairs
8. Install the engine and transmission gear box assembly on the engine base.
9. Secure the transmission gear box to engine base with 2 bolts (9). Do not
tighten the bolts (9).
10. Secure the engine to the engine base with 4 carriage bolts, washers and nuts.
11. Secure the engine base (item 1 in
a bolt (7), 2 washers (5) and nut (4) in front side and 2 tube clamps (8) and 4
nuts (11) in rear side of the frame assembly (6). Do not tighten the nuts (4
and 11).
12. Tighten the nut (4). Torque tighten the nuts (11) in a criss cross pattern from
3.4 to 4 N·m (30 to 35 in-lb) and then using the same pattern apply the
torque from 5.6 to 6.2 N·m (50 to 55 in-lb).
13. Tighten the 2 bolts (9) that secure the transmission gear box to engine base.
14. Install the slider adapter (item 2 in
onto the transmission gear box assembly (10). Adjust the slider adapter to
make sure that the transmission output shaft is in neutral position.
15. Install the 2 splined couplers onto the transmission gear box assembly and
drum drive gear box assembly and secure with the truss screw, 2 washers
and nut.
16. Torque tighten the truss screw to 10 to 12.4 N∙m (90 to 110 in-lb).
17. Install the reel cable; refer to
18. Install the brake cable; refer to
19. Install the clutch cable; refer to
20. Install the throttle cable; refer to
21. Attach the spark plug wire to the spark plug. Open the fuel shut-off valve
on the fuel tank.
22. Start the engine and allow it to warm to operating temperature. Check high
and low idle speeds and adjust if necessary.
Figure 16) to the frame assembly (6) with
Figure 16) and secure with a jam nut (3)
Installing the Reel Cable (page
Installing the Brake Cable (page
Installing the Clutch Cable (page
Installing the Throttle Cable (page
Page 4–16
7–13).
7–8).
7–10).
7–5).
Greensmaster ® 1018/1021/1026
18238SL Rev B