Installing the Front Roller (continued)
Greensmaster
®
1018/1021/1026
18238SL Rev B
5. Slide the remaining height-of-cut arm (5) onto the other end of roller shaft.
Secure the remaining height-of-cut arm to the side plate with a plow bolt (2),
height-of-cut washer and lock nut.
6. Center the front roller (3) in the cutting unit and tighten the pinch bolts (8) that
secure the front roller shaft to the height-of-cut arms.
7. Install the cutting unit assembly to the frame assembly; refer to
Cutting Unit Assembly (page
8. Adjust the cutting unit height-of-cut; refer to the Cutting Unit Operator's
Manual.
8–17), (If necessary).
Page 8–27
Installing the
DPA Cutting Units: Service and Repairs