Servicing The Bedbar Adjuster - Toro Greensmaster 1018 Service Manual

Servicing the Bedbar Adjuster

Removing the Bedbar Adjuster
g261412
1. Bedbar adjuster shaft (2 each)
2. Keyed flanged bushing (4 each)
3. Detent (2 each)
4. Bolt (2 each)
DPA Cutting Units: Service and Repairs
5. Wave washer (2 each)
6. Retaining ring (2 each)
7. Bedbar adjuster screw (2 each)
8. Bedbar assembly
Note: Refer to Figure 72
1. Remove bedbar; refer to
2. Remove the lock nut (11), compression spring (10) and washer (9) from the
bedbar adjuster screw (7).
Note: The bedbar adjuster shaft (1) has left-hand threads.
3. Unscrew the bedbar adjuster shaft (1) from the bedbar adjuster screw (7).
4. Remove the retaining ring (6) and wave washer (5) from the adjuster shaft
(7) and remove the adjuster shaft.
5. Inspect the flange bushings (2) in the cutting unit side plate (12) and replace
them if necessary.
6. Inspect the detent (3) and replace it if necessary.
Figure 72
10.
11.
12.
during this procedure.
Removing the Bedbar (page
Page 8–10
9. Washer (2 each)
Compression spring
Nut (2 each)
Side plate
8–7).
Greensmaster ® 1018/1021/1026
18238SL Rev B