Reel Drive Assembly
g258675
1.
Screw (2 each)
2.
Spacer (2 each)
3.
Washer (2 each)
4.
Spring washer (2 each)
Removing the Reel Drive Assembly
Greensmaster
®
1018/1021/1026
18238SL Rev B
5.
V-ring seal
6.
Reel drive assembly
7.
Compression spring
8.
Telescopic coupler
Note: Refer to
Figure 22
1. Park the machine on a level surface. Ensure that the engine is OFF. Remove
the spark plug wire from the engine spark plug.
2. Slide the telescopic coupler (item 8 in
(6) and disconnect the reel drive shaft from the transmission drive shaft (10).
3. Loosen and remove the 2 screws (1) and the nut (12) that secures the reel
drive assembly (6) to RH side plate (9). Remove the reel drive assembly
(6), flat washers (3), spring washers (4) and spacers (2 and 11) from the
RH side plate (9).
4. Remove the V-ring seal (5) from the reel drive assembly (6).
Figure 22
10.
11.
12.
during this procedure.
Figure
Page 5–7
Traction and Reel Drive Systems: Service and Repairs
9.
RH side plate
Transmission drive shaft
Spacer
Nut
22) on the reel drive assembly