Bedknife - Toro Greensmaster 1018 Service Manual

Bedknife

Removing the Bedknife
Installing the Bedknife
DPA Cutting Units: Service and Repairs
g227001
1. Bedknife screw (13 used)
2. Bedknife
1. Remove the bedbar from the cutting unit; refer to
(page 8–7).
2. Remove screws from bedbar using a socket wrench and bedknife screw
tool; refer to Bedknife Screw Tool (page
bedknife from the bedbar.
3. Refer to Grinding the Bedknife (page 8–14)
1. Use a scraper to remove all rust, scale and corrosion from the bedbar
surface under the bedknife. Lightly oil the bedbar surface before installing
the bedknife.
2. Make sure that screw threads in bedbar (5/16-18UNC-2A) are clean.
g226894
Figure 73
3. Bedbar
2–16). Discard the screws. Remove
Figure 74
Page 8–12
Removing the Bedbar
for additional information.
Greensmaster ® 1018/1021/1026
18238SL Rev B