Toro Greensmaster 1018 Service Manual page 53

Removing the Engine Base (continued)
Installing the Engine Base
Greensmaster ® 1018/1021/1026
18238SL Rev B
19. If necessary, remove the flange bushing (7) from the reel bellcrank (8).
Remove the straight bushing (11) from the long and short reel lever (10 and
12).
20. If necessary, remove the nut (14), washer (23) and socket head screw (15)
from the engine base (16).
1. If removed, install the socket head screw (item 15 in
and nut (14) into the engine base (16).
g262534
1. Long reel lever
Straight bushings in the long and short reel levers must be inspected
for wear or damage and replaced if needed.
2. If removed, install the straight bushings (11) into the long and short reel
levers (10 and 12) using an arbor press. Ensure that the straight bushings (3)
are flush to top of the long and short reel levers (1 and 2); refer to
3. If removed, install the flange bushing (7) into the reel bellcrank (8) using
an arbor press.
4. Slide the reel bellcrank (8), washer (9), short reel lever (12), washer (9), long
reel lever (10) and washer (9) onto the reel selector shaft (5).
5. Install the reel selector shaft (5) onto engine base (16) and secure with the
bolt (13).
6. Carefully position the extension spring (6) onto the long and short reel levers
(10 and 12).
7. Install the reel selector hub (3) and compression spring (2) onto the reel
selector shaft (5) and secure with the nut (1).
Support the engine and transmission to prevent it from dropping
and causing personal injury when installing.
Figure 18
2. Short reel lever
IMPORTANT
WARNING
Page 4–15
Figure 17), washer (23)
3. Straight bushing
Figure
Gasoline Engine: Service and Repairs
18.