Roller Assemblies - Toro Greensmaster 1018 Service Manual

Roller Assemblies

Removing the Front Roller
DPA Cutting Units: Service and Repairs
g261580
1. Plow bolt (2 each)
2. Socket head screw (4 each)
3. Front roller assembly
4. Mounting rod (2 each)
5. Height-of-cut arm (2 each)
Note: Refer to Figure 81
1. Loosen the pinch bolts (8) that secure the front roller shaft (3) to the front
height-of-cut arms (5).
2. Remove the lock nut (6), height-of-cut washer (7) and plow bolt (1) that
secures one of the height-of-cut arms (5) to the cutting unit side plate (10)
and remove the height-of-cut arm.
3. Slide the front roller assembly (3) from the remaining height-of-cut arm (5).
4. Remove the remaining height-of-cut arm (5) from the cutting unit (10) if
necessary.
Figure 81
6. Lock nut (2 each)
7. Height-of-cut washer (2 each)
8. Pinch bolt (2 each)
9. Height-of-cut screw (2 each)
10. Cutting unit assembly
during this procedure.
Page 8–24 Greensmaster ® 1018/1021/1026
18238SL Rev B