Cloning I Pc Connection Functions 1; How To Connect; Operating The Transceiver Sending Data - Alinco DJ-G7 Instruction Manual

104
12.Cloning I PC Connection Functions
12.
Cloning I PC Connection Functions
The cloning function copies data from one DJ-G7 transceiver to another DJ-G7
transceiver. Two DJ-G7 transceivers are connected by a cable and information
(including memory data) from the sending unit will be copied to the receiving unit
when using this function.
The DJ-G7 can also be connected to a PC and memory channels and/or the Set
mode settings can be edited using specialized software.
12-1 How to Connect
'When using the cloning function, an optional clone cable (EDS-11) will be
connected from the sender's earphone/microphone terminal to the receiver's
earphone/microphone terminal.
-When connecting this transceiver to a PC, an optional microphone/speaker plug
conversion cable (EDS-14) is connected to the earphone/microphone terminal
of this transceiver and the plug of a PC connecting cable (ERW-7/ERW-4C) and
connected to the PC.
• Clone cable (EDS-11)
Sender Receiver
Connecting to Connecting to
the earphone terminal 01 the earphone terminal
DJ-G7 01 DJ-G7
=
JJi=2'
~:~:"t:::"~':--=-il
=
( 12-2 Operating the Transceiver Sending Data
When sending and receiving clone data between DJ-G7 transceivers, or when
transferring data with a PC, follow these procedures:
1.Connect a clone cable (EDS-11) to the earphone/microphone terminal while
the transceiver is turned off, and then turn the transceiver on.
2.Press and hold the [MONI] key then press the [PTT] key 3 times. The
transceiver will be in the clone mode and is ready to transfer data.